I have a 1997 jeep wrangler. I purchased a hardtop that needs windows installed in it. I have purchased used windows. How do you install the windows in this hardtop?
-
Recent Posts
- How do you remove the front seats of a 2000 jeep wrangler tj?
- Jeep CJ7 for sale in south Georgia for under $3000?
- Any idea where i could get a used jeep wrangler for cheap?
- How to replace a gas filter in a 2000 Jeep Sahara Wrangler ?
- Is it possible to convert a Jeep Wrangler Soft top into a Hard top?
Recent Comments
- Noah's Ark on Jeep CJ7 for sale in south Georgia for under $3000?
- Seahorse on Jeep CJ7 for sale in south Georgia for under $3000?
- Cheech on How do you remove the front seats of a 2000 jeep wrangler tj?
- loonatic72 on How do you remove the front seats of a 2000 jeep wrangler tj?
- XdeathwarmedupX on Jeep CJ7 for sale in south Georgia for under $3000?
Archives
Categories
Meta
Short answer: I recommend taking it to an auto glass shop or a Jeep dealership. If you have the glass already, the installation should be fairly inexpensive.
The procedure is covered in detail in the factory service manual (a very good investment for any do-it-yourself Jeep owner, and not too expensive on ebay). Glass installation is not trivial. I’ll try to condense the instructions here:
1. Trim the urethane from the opening, leaving a 3mm level base. Place glass in the opening and make sure it fits and seats against the level urethane. Make alignment marks with a grease pencil
2. Remove the glass to a workbench, lay flat, inside-up.
3. Clean the glass with ammonia-based glass cleaner, then clean outer edge of glass with naphtha
4. Apply molding to perimeter of glass with butt-weld in the molding at the bottom center of the glass.
5. Apply “glass prep” adhesion promotor 1″ wide around perimeter of glass, wipe with lint-free cloth until no streaks.
6. Apply “glass primer” 1″ wide around perimeter of glass. Allow 3 minutes or more drying time
7. Apply “pinchweld” primer 3/4″ wide around the quarter glass fence (on the hard top). Allow 3 minutes or more drying time
8. Apply a 0.4″ diameter bead of urethane to the center of the quarter glass fence surface area. (I quoted this instruction directly). Go to step 9 immediately – you only 10-15 minutes before the urethane starts to cure.
9. Align the glass with the grease pencil marks and push inward “until the reveal molding is seated on the hardtop.” Don’t push so hard that too much adhesive squeezes out.
10. Open windows and liftgate while urethane cures to avoid pressure buildup. Apply 2″ masking tape strips every 10″. After urethane cures, remove tape strips and water-test.
Damn, after i read this guys answer I pretty much am speechless!